Power switch
The power switch is located on the end of the curved handle.
To turn hand vacuum ON ( I ), press up.
To turn hand vacuum OFF ( 0 ), press down
Cleaning with flexible rubber contour nozzle
1. Turn hand vacuum OFF.
2. Remove hard nozzle by pressing down on
round nozzle release button.
3. Replace with flexible rubber contour nozzle by lining
up the bottom of nozzle to the bottom of the dirt
container. Pivot upwards until it snaps into place.
4. Make sure the nozzle has snapped securely
into place before using
Emptying the dirt container
Empty the dirt container after each use. A
full dirt container may reduce suction or
performance of vacuum.
1. Turn hand vacuum OFF.
2. Unplug hand vacuum from electrical outlet.
3. Press dirt container release latch down to
disconnect dirt container and filter assembly
from the unit.
4. Remove filter by grasping tabs on both sides
of filter frame and pulling away from the dirt
container. For best results, periodically tap
filter assembly against trash can to remove
dirt that has collected on the screen and
filter.
5. Empty dirt into trash can.
6. Replace filter assembly by aligning side
labeled “TOP” into top of dirt container.
Grasp filter tabs and press firmly to ensure
filter assembly is secure in dirt container.
NOT E: Make sure side of filter assembly
labeled "TO P" faces outward when inserting
filter assembly into dirt container.
7. Reattach dirt container to unit by aligning
bottom of dirt container to bottom of unit.
Pivot upwards and snap into place. Use one
hand to hold the unit and use the other hand
to clip the dirt container securely in place